</a>放大器" title="放大器">放大器" title="放大器">放大器能直接連接到ADC,增益設定為64,4.17Hz的噪音為40nV,工作電壓2.7-5.25V, 主要用在熱電偶測量,RTD測量,氣體分析,工業過程控制,手持儀表,血液分析以及6位DVM等.本文介紹了AD7793主要特性,方框圖, RTD和熱電偶測量電路圖以及采用AD7793 24位Sigma-Delta ADC完整的熱電偶測量系統電路圖和材料廠清單.
The AD7792/AD7793 are low power, low noise, complete analog front ends for high precision measurement applications. The AD7792/AD7793 contain a low noise 16-/24-bit Σ-Δ ADC with three differential analog inputs. The on-chip, low noise instrumentation amplifier means that signals of small amplitude can be interfaced directly to the ADC. With a gain setting of 64, the rms noise is 40 nV when the update rate equals 4.17 Hz.
The devices contain a precision low noise, low drift internal band gap reference and can accept an external differential reference. Other on-chip features include programmable excitation current sources, burnout currents, and a bias voltage generator. The bias voltage generator sets the common-mode voltage of a channel to AVDD/2.
The devices can be operated with either the internal clock or an external clock. The output data rate from the parts is software-programmable and can be varied from 4.17 Hz to 470 Hz.
The parts operate with a power supply from 2.7 V to 5.25 V. They consume a current of 400 μA typical and are housed in a 16-lead TSSOP package.
AD7793主要特性:
Up to 23 bits effective resolution
RMS noise
40 nV @ 4.17 Hz
85 nV @ 16.7 Hz
Current: 400 μA typical
Power-down: 1 μA maximum
Low noise programmable gain instrumentation amp
Band gap reference with 4 ppm/°C drift typical
Update rate: 4.17 Hz to 470 Hz
3 differential inputs
Internal clock oscillator
Simultaneous 50 Hz/60 Hz rejection
Programmable current sources
On-chip bias voltage generator
Burnout currents
Power supply: 2.7 V to 5.25 V
–40°C to +105°C temperature range
Independent interface power supply
16-lead TSSOP package
Interface
3-wire serial
SPI®, QSPI™, MICROWIRE™, and DSP compatible
Schmitt trigger on SCLK
AD7793應用:
Thermocouple measurements
RTD measurements
Thermistor measurements
Gas analysis
Industrial process control
Instrumentation
Portable instrumentation
Blood analysis
Smart transmitters
Liquid/gas chromatography
6-digit DVM
圖1.AD7793方框圖
圖2.采用AD7792/3的RTD應用電路圖
圖3.采用AD7792/3的熱電偶測量電路圖
采用AD7793 24位Sigma-Delta ADC完整的熱電偶測量系統
Complete Thermocouple Measurement System Using the AD7793 24-Bit Sigma-Delta ADC
The circuit, shown in Figure 4, is a complete thermocouple system based on the AD7793 24-bit sigma-delta ADC. The AD7793 is a low power, low noise, complete analog front end for high precision measurement applications. The device includes a PGA, internal reference, internal clock, and excitation currents, thereby greatly simplifying the thermocouple system design.
圖4.帶冷端補償的熱電偶測量系統電路圖(簡化電路圖:所有的連接和去偶電容未標)
圖5. 熱電偶測量系統外形圖
CN206熱電偶測量系統材料清單見:
CN206熱電偶測量系統材料清單.xls
詳情請見:
http://www.analog.com/static/imported-files/circuit_notes/CN0206.pdf
和
http://www.analog.com/static/imported-files/data_sheets/AD7792_7793.pdf
The AD7792/AD7793 are low power, low noise, complete analog front ends for high precision measurement applications. The AD7792/AD7793 contain a low noise 16-/24-bit Σ-Δ ADC with three differential analog inputs. The on-chip, low noise instrumentation amplifier means that signals of small amplitude can be interfaced directly to the ADC. With a gain setting of 64, the rms noise is 40 nV when the update rate equals 4.17 Hz.
The devices contain a precision low noise, low drift internal band gap reference and can accept an external differential reference. Other on-chip features include programmable excitation current sources, burnout currents, and a bias voltage generator. The bias voltage generator sets the common-mode voltage of a channel to AVDD/2.
The devices can be operated with either the internal clock or an external clock. The output data rate from the parts is software-programmable and can be varied from 4.17 Hz to 470 Hz.
The parts operate with a power supply from 2.7 V to 5.25 V. They consume a current of 400 μA typical and are housed in a 16-lead TSSOP package.
AD7793主要特性:
Up to 23 bits effective resolution
RMS noise
40 nV @ 4.17 Hz
85 nV @ 16.7 Hz
Current: 400 μA typical
Power-down: 1 μA maximum
Low noise programmable gain instrumentation amp
Band gap reference with 4 ppm/°C drift typical
Update rate: 4.17 Hz to 470 Hz
3 differential inputs
Internal clock oscillator
Simultaneous 50 Hz/60 Hz rejection
Programmable current sources
On-chip bias voltage generator
Burnout currents
Power supply: 2.7 V to 5.25 V
–40°C to +105°C temperature range
Independent interface power supply
16-lead TSSOP package
Interface
3-wire serial
SPI®, QSPI™, MICROWIRE™, and DSP compatible
Schmitt trigger on SCLK
AD7793應用:
Thermocouple measurements
RTD measurements
Thermistor measurements
Gas analysis
Industrial process control
Instrumentation
Portable instrumentation
Blood analysis
Smart transmitters
Liquid/gas chromatography
6-digit DVM
圖1.AD7793方框圖
圖2.采用AD7792/3的RTD應用電路圖
圖3.采用AD7792/3的熱電偶測量電路圖
采用AD7793 24位Sigma-Delta ADC完整的熱電偶測量系統
Complete Thermocouple Measurement System Using the AD7793 24-Bit Sigma-Delta ADC
The circuit, shown in Figure 4, is a complete thermocouple system based on the AD7793 24-bit sigma-delta ADC. The AD7793 is a low power, low noise, complete analog front end for high precision measurement applications. The device includes a PGA, internal reference, internal clock, and excitation currents, thereby greatly simplifying the thermocouple system design.
圖4.帶冷端補償的熱電偶測量系統電路圖(簡化電路圖:所有的連接和去偶電容未標)
圖5. 熱電偶測量系統外形圖
CN206熱電偶測量系統材料清單見:
CN206熱電偶測量系統材料清單.xls詳情請見:
http://www.analog.com/static/imported-files/circuit_notes/CN0206.pdf
和
http://www.analog.com/static/imported-files/data_sheets/AD7792_7793.pdf
本站內容除特別聲明的原創文章之外，轉載內容只為傳遞更多信息，并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題，請及時通過電子郵件或電話通知我們，以便迅速采取適當措施，避免給雙方造成不必要的經濟損失。聯系電話：010-82306118；郵箱：aet@chinaaet.com。