ST公司的STPMS1是嵌入PGA的雙路1位2MHz1階Sigma0Delta調制器,也稱為智能傳感器" title="傳感器">傳感器. STPMS1是混合信號器件,包括了模擬和數字部分, 模擬部分包括前置放大器和連個1階Sigma0Delta調制器區塊,能帶隙基準電壓,低壓降穩壓器和DC緩沖器;而數字部分包括時鐘發生器和輸出復接器.器件具有中等分辨率.VCC電源3.2V-5.5V,支持50-60Hz 交流電表,主要應用在電表,馬達控制,工業過程控制,衡器和壓力傳感器.本文介紹了STPMS1主要特性,方框圖, 應用電路圖, 電表應用電路圖和基于DSP的應用框圖,以及多相演示板STEVAL-IPE010V1方框圖,主板和子板電路圖和相應的材料清單(BOM).

STPMS1: Dual-channel 1-bit, 2 MHz, 1st order sigma-delta modulator with embedded PGA

The STPMS1, also called a smart-sensor device, is an ASSP designed for effective measurement in power line systems utilizing the Rogowski coil, current transformer, or shunt principle. It is used in combination with the STPMC1 programmable poly-phase energy calculator IC, as a building block for single-phase or poly-phase energy meters. The STPMS1 is a mixed signal IC consisting of an analog and a digital section. The analog section consists of a pre-amplifier and two 1st order ΣΔ modulator blocks, band-gap voltage reference, a low-drop voltage regulator, and DC buffers, while the digital section consists of a clock generator and output multiplexer. This device is designed for use in medium resolution

STPMS1主要特性:

■ VCC supply range: 3.2 V - 5.5 V

■ Two 1st order sigma-delta modulators

■ Programmable chopper-stabilized low noise and low offset amplifier

■ Supports 50-60 Hz AC watt meters

■ Internal low-drop regulator at 3 V (typ.)

■ Precision voltage reference: 1.23 V and 30 ppm/°C (typ.)

STPMS1應用:

■ Power metering

■ Motor control

■ Industrial process control

■ Weight scale

■ Pressure transducers

圖1.STPMS1方框圖

圖2.STPMS1應用電路圖:● P = 64000 imp/kWh,● INOM = 5 A,● IMAX = 60 A

圖2.STPMS1電表應用電路圖

圖3.STPMS1基于DSP應用的連接框圖

STPMC1和STPMS1多相演示板STEVAL-IPE010V1

STEVAL-IPE010V1 poly-phase demonstration kit for the STPMC1 and STPMS1

This application note describes the STEVAL-IPE010V1 poly-phase demonstration kit for the STPMC1 and STPMS1.The STPMC1 is a metering ASSP implemented through an advanced 0.35 μm BCD6 technology.

The STPMC1 device functions as an energy calculator in power line systems, using the Rogowski current transformer and shunt or Hall current sensors. It is used in combination with one or more STPMS1 devices. It implements all the functions needed in a 1, 2 or 3- phase energy meter, providing the effective measurement of active and reactive energies, VRMS, IRMS, instantaneous voltage and current-per-phase in 1, 2 or 3-phase wye and delta services, from 2 to 4 wires.

In a stand-alone configuration the STPMC1, which sends a pulse train signal with a frequency proportional to the cumulative active power, can directly drive a stepper motor,therefore implementing a simple active energy meter.

This device can also be coupled to a microprocessor for multi-function energy meters. In this case, the measured data is read at a fixed time interval from the device internal registers by the microcontroller through the SPI interface.

The STPMS1 is an ASSP designed as a building block for single or multi-phase energy meters. It consists of a pre-amplifier and two 1st order Delta-Sigma ?modulators, band-gap voltage reference, a low-drop voltage regulator and DC buffers in its analog section, and a clock generator and output multiplexer in its digital section.

The demonstration kit is made up of a main board with the STPMC1 mounted, and it can be coupled with up to 5 daughterboards, each with an STPMS1 mounted to sense the voltage and current of each phase.

圖4.多相演示板STEVAL-IPE010V1方框圖

圖5.STPMC1電路圖

圖6.主板連接器電路圖

圖7.子板電路圖
主板材料清單(BOM):


子板材料清單(BOM):


詳情請見:
http://www.st.com/internet/com/TECHNICAL_RESOURCES/TECHNICAL_LITERATURE/DATASHEET/CD00253174.pdf
和
http://www.st.com/internet/com/TECHNICAL_RESOURCES/TECHNICAL_LITERATURE/APPLICATION_NOTE/CD00264959.pdf